HP Linux Server Management Software - Manual (Page 58)

Toolkit utilities 58
Command-line argument Description
BootDeviceLUN[0]=1111 Your input, default LUN, or current value when read from
HBA
HPLPCFG return codes
Value Meaning
0 The command was completed successfully.
1 There was an invalid command line option.
2 There was a file open error.
3 There was an NVRAM checksum error.
4 There was an NVRAM data error.
5 There was no adapter or Emulex HBA found on this host.
6 There was an error retrieving the I/O address.
7 The WWID was invalid because of one of the following:
• An invalid value for WWID and BootDeviceWWID, and not a hex value
• The WWID specified for HBA in the .ini file does not match any HBAs found on the
host (for the /l option only)
8 The LUN was invalid.
0x10 Invalid value; for enable/disable value is not 0 or 1 (for /l option only)
0x11 Incorrect iboot BIOS code loaded (for /l option only)
0xFF General error:
• Initialization error (for both /l and /s option)
• Cannot read HBAs WWPN (for /s option only)
HPLPCFG command-line examples
hplpcfg /s hba.ini generates hba.ini with the following content:
[HBA0]
WWID=11111111
HostAdapterBiosEnable=1
SelectBootEnable=1
BootDeviceWWID=
BootDeviceLUN[0]=
You must edit hba.ini and add the following boot device information:
[HBA0]
WWID=11111111
HostAdapterBiosEnable=1
SelectBootEnable=1
BootDeviceWWID=22222222
BootDeviceLUN[0]=3