HP Linux Server Management Software - Manual (Page 56)

Toolkit utilities 56
Error code Error message Comment or clarification
2851 Invalid RAID Array ID. The scripted RAID Array ID is invalid. Use characters from the
set a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +, :, ., /, and
[space]. The ID cannot end with a space character or exceed
the maximum number of characters allowed by the controller.
2852 Invalid SSP state. —
2853 Cannot change SSP
settings.
—
2854 Invalid SSP adapter ID. —
2855 Controller does not support
logical drive SSP states. Use
the SSPState controller
command to set the
controller SSP state.
—
2856 Controller does not support
controller SSP state. Use the
LogicalDriveSSPState logical
drive command to set SSP
states for each logical drive.
—
2857 Invalid surface scan delay. —
2861 Controller does not support
redundancy settings.
The controller is not redundant or does not support
redundancy settings.
2864 Invalid preferred path
mode.
The specified value for the preferred path mode is not valid,
or the controller is not available.
2865 Invalid preferred path. The specified preferred path is not a valid chassis slot for an
available active controller, or the controller is not available.
2866 Failure opening capture file
.
—
2867 Failure opening input file
.
—
2868 Failure opening error file
.
—
2869 command expected. The command is missing or in the wrong place in the
script file.
2870 is not a supported
command. —
2871 is not a Controller
command. The command does not belong in the Controller
section of the script file.
2872 is not an Array
command.
The command does not belong in the Array section of
the script file.
2873 is not a Logical Drive
command.
The command does not belong in the Logical Drive
section of the script file.
2874 is not an HBA
command.
The command does not belong in the HBA section of
the script file.
2875 More than one
command cannot exist in
the same section.
—