Operation, Switching on the drive, Using your tape drive – HP StorageWorks DLT VS80 Tape Drive User Manual
Page 10: Jammed cartridge, Operating the tape drive, Operate, If you have problems during self test, Resetting the drive
operation
hp learning products
may have a later version
data protection
operation
operation
contents of this section
if you have problems during self
test
related topics
interpreting the front panel lights
switching on the drive
Internal drives are powered on when you switch on your computer.
Switch on external drives using the power switch on the rear of the drive, and then
switch on the computer.
Removable drives are powered on when you switch on your tape array and
computer.
if you have problems during self test
If all the LED lights on the front panel are flashing at the end of the self-test, this
indicates a fault has occurred:
If you have just installed the drive, check the installation for loose
connections and repeat the self-test.
Try the
is.
If the fault condition persists, call for
resetting the drive
The drive can be reset without powering off the drive and computer, for example,
if the drive stops responding. To reset the drive, press and hold the eject button
until all three LEDs come on (which takes about 6 seconds), then release the
button.
If the eject button is held down until the LEDS come on (6 seconds) and is
continued to be held down, until the lights go off (another 4 seconds), no reset is
performed.
If you press and hold the eject button again until the first two LEDs flash, the
drive goes into a state ready for the
to its normal state after 30-45 seconds of inactivity.
© 2001, Hewlett-Packard Company
file:///C|/Documents%20and%20Settings/topher.COL-SPRINGS/Desktop/dltvs80%20manual/document/dltvs80/user/reseller/eng/operate.htm [11/29/2001 8:33:50 AM]