HP Integrity NonStop H-Series - Manual (Page 31)

Running SWID With Customized Switches
Software Identification (SWID) User’s Guide — 527243-004
4 -3
-FT (Fingerprint Type)
-FT (Fingerprint Type)
The -FT switch option causes SWID to generate the requested fingerprint type for the
specified file or files. The -FT switch option has the format -
FT num . The parameter
num specifies this fingerprint type. An error is returned if the type does not exist for a
file. The -FT switch is not valid when used with the -BS, -SC, or -DA switch. The value
specified for
num must not exceed four digits. Valid values for num and their meanings
are:
-FA (Format Archaic)
The -FA switch option causes SWID to output in a format similar to the -DV switch.
This format is compatible to that generated by an earlier product version of SWID. In
this format, file information such as file name, current fingerprint, original fingerprint,
version procedures, and Binder timestamp appear on a separate line. Without the -FA
switch (such as using the current format), all information about a file is displayed on
one line.
Value Meaning
0 Ordinary fingerprint. Applies to all file codes. Also defined as the
DEFAULT TYPE.
1 This fingerprint type applies to file code 100 and 800 loadfiles when
fingerprint Version 2 or higher is requested, and to file code 700
executable ELF files when fingerprint Version 1 or higher is requested.
This fingerprint type does not apply to code 700 COFF files.
If a file is not a code 100, 700 (ELF format), or 800 file, the following
error message is dispayed:
Not Computed
Fpts type not supported
63 Invalid file format fingerprint. Applies only to code 0 OSIMAGE files
and other code 0 files. If a file is not a code 0 file, the following error
message is displayed:
Not Computed
Fpts type not supported
other values No other types are supported for any fingerprint version. If any other
value is specified, the following error message is displayed:
Not Computed
Fpts type not supported