HP Remote Insight Lights-Out Edition II Board User Manual
Page 95
Troubleshooting 95
7.
Verify that HP Network Node Manager can acquire operating system information from the target
system:
a.
Run the HP NNM MIB browser (%OV_BIN%/xnmbrowser).
b.
Enter the host name or IP address of the system.
c.
Enter the community name to use for communication.
d.
Enter
.1.3.6.1.4.1.232.11.2.2
for the MIB Object ID.
e.
Click Start Query.
The results display the operating system name and version in the MIB Values field, similar to the following
(depending on the operating system):
1.0:Microsoft® Windows NT® Server
2.0:4.00
3.0:Service Pack 6 1381 Uniprocessor Free
4.0:3
5.0:3
If you do not obtain results, the system cannot communicate with the HP Insight Management Agents.
Why do the HP Insight Information options return errors when querying a node?
You must install and configure SNMP for the Insight Information menu items to work properly. In addition,
you must configure the correct community string within NNM.
If you receive the error, "Could not perform SNMP get from HOSTNAME: No response arrived before
timeout," verify that you are using the correct SNMP community string.
If you receive the message, "Note: requested information is not available from HOSTNAME," be aware
that, in most cases, this message is not an error. The most likely cause of this message is that you are
requesting information that is not implemented on the target node. For example, selecting Insight
Information>Drives>SCSI on a system that only has a drive array (no SCSI devices) can cause this
message.
Why are RILOE, RILOE II, iLO, or iLO 2 management processors not discovered and associated with the
server?
The HP Insight Management Agents must be installed and configured on the target server and the Remote
Insight Agent must be running.
Why are systems not appearing on the NNM segment map even though the Insight Integration is
installed?
1.
Verify that HP Insight Management Agents are installed and active. If HP Insight Management
Agents are not in use or not correctly enabled, your systems are not discovered. At a minimum, HP
recommends HP Management Agents for Servers 5.0 or later and HP Management Agents for
Clients 4.20 or later.
2.
Be sure that the CPQDIS background process is running by using the
OVSTATUS
command
("
Checking the status of HP background processes
If the problem persists, you might have a general configuration or communication problem ("
the configuration
" on page
97
).
Why does the Insight Agent icon within the NNM device window display WEB DISABLED and the HP
Management Agent launch does not execute?