HP Photosmart p1000 1000 Printer - Manual (Page 75)

Troubleshooting
www.hp.com/photosmart 69
When I connect a USB
cable between the printer
and my computer, the
“New Hardware Wizard”
message does not appear.
(Windows PC only)
You may not be using
Windows 98, 2000, or
Me.
Make sure your computer’s operating system is Windows 98, 2000,
or Me and that your computer is connected using a USB cable. If you
do not have Windows 98, 2000, or Me, you need to use a parallel
cable.
Your USB cable may not be
working or may not be
connected properly.
1. Disconnect and then reconnect the USB cable from your printer.
2. Make sure the cable is securely attached both to the computer
and to the printer.
3. If you are still having problems, try using another USB cable.
You may not have USB
enabled.
1. In Windows 98, 2000, or Me, click Start , Settings , Control
Panel .
2. Double-click the System icon.
3. Click the Device Manager tab.
4. Click the (+) icon next to the Universal Serial Bus Controller
option. If you see a USB host controller and a USB root hub
listed, USB is probably enabled. If you do not see these devices
listed, refer to your computer’s documentation or contact the
manufacturer for more information on enabling and setting up
USB.
If you cannot enable USB, you can always use a parallel cable to
connect your printer to your computer.
Problem Possible cause Solution