HP Photosmart p1000 1000 Printer - Manual (Page 18)

hp photosmart 1000 color printer user’s guide
12 www.hp.com/photosmart
To... Follow these steps...
Load paper in the paper
tray
Use the printer’s paper tray to
print on many different types of
paper. You can use everything
from plain paper to HP Premium
Inkjet Transparency Film.
1. Pull out the front paper guide on the paper tray
and slide the side paper guide as far to the left
as it will go.
2. Place a stack of paper into the paper tray.
• Load the paper print side down . The
printer prints on the face-down side of the
paper in the paper tray; the printed
document faces up in the output tray.
• Always load paper in the portrait
direction, with the long edge against the
long edge of the paper tray.
• Be careful not to use too much or too little paper. It may be difficult for the printer to
“grab” a sheet of paper when there are only one or two sheets in the paper tray.
Check that the stack of paper contains several sheets but is no higher than the top of
the front paper guide.
• Use one kind and size of paper at a time. Do
not mix paper types or sizes in the paper tray.
3. On the output tray, move the slider (visible through
the output tray) toward you (away from the inside of
the printer) until it stops. This disengages the photo
tray.
4. Adjust the side and front paper guides to fit close to
the edges of the paper, without bending the paper.
This helps the paper feed straight into the printer.
Front paper
guide
Side paper
guide