HP Scripting Toolkit for Windows - Manual (Page 44)

Comment or clarification Error message Error code
The scripted RAID Array ID is invalid. Use characters from
the set a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +, :, ., /, and Invalid RAID Array ID. 2851
[space]. The ID cannot end with a space character or exceed
the maximum number of characters allowed by the controller.
— Invalid SSP state. 2852
— Cannot change SSP settings. 2853
— Invalid SSP adapter ID. 2854
— Controller does not support logical drive
SSP states. Use the SSPState controller
command to set the controller SSP state. 2855
— Controller does not support controller SSP
state. Use the LogicalDriveSSPState logical 2856
drive command to set SSP states for each
logical drive.
— Invalid surface scan delay. 2857
The controller is not redundant or does not support
redundancy settings. Controller does not support redundancy
settings. 2861
The specified value for the preferred path mode is not valid,
or the controller is not available. Invalid preferred path mode. 2864
The specified preferred path is not a valid chassis slot for an
available active controller, or the controller is not available. Invalid preferred path. 2865
— Failure opening capture file . 2866
— Failure opening input file . 2867
— Failure opening error file . 2868
The command is missing or in the wrong place in the
script file. command expected. 2869
— is not a supported command. 2870
The command does not belong in the Controller section
of the script file. is not a Controller command. 2871
The command does not belong in the Array section
of the script file. is not an Array command. 2872
The command does not belong in the Logical Drive
section of the script file. is not a Logical Drive command. 2873
The command does not belong in the HBA section of
the script file. is not an HBA command. 2874
— More than one command cannot
exist in the same section. 2875
The script specifies more drives than are available of the
specified drive type. Invalid physical drive count. 2876
No drives were found that could be used as spares for the
specified array. No spares available. 2877
RAID 0 does not support spares. Spare request for RAID 0 is invalid. 2878
A controller reset with data loss was specified while in
Reconfigure mode. Reset and reconfigure combined error. 2879
— Invalid drive type specified. 2880
44 Scripting Toolkit utilities