Avaya P332MF - Manual (Page 122)

Chapter 6 CLI – Layer 2
106 Avaya P332MF User’s Guide
set port redundancy on/off
Use the set port redundancy command to define/delete port redundancy
schemes between a Primary and a Secondary link. There should not be any
redundancy scheme already defined on any of the links.
The syntax for this command is:
set port redundancy / /
{on/off} []
Output Example:
P330-N# set port redundancy 1/7 2/12 on red1
uplink: Port 2/12 is redundant to port 1/7.
Port redundancy is active - entry is effective immediately
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
set port redundancy
Use the set port redundancy commands to activate or disable all defined port
redundancy schemes within the stack. This command will not delete existing port
redundancy entries. A port redundancy scheme is removed once the switch
containing either its primary or secondary ports is removed from the stack.
Note: You must disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy {enable|disable}
Output Example:
P330-N# set port redundancy enable
All redundancy schemes are now enabled
prim_port_num Primary link of the redundancy scheme
second_port_num Secondary link of the redundancy scheme
redundancy_name Name for the redundancy scheme (optional)