Adaptec SATA AND SCSI RAID CONTROLLERS User Manual
Page 99
C-6
Adaptec Flash Utility (AFU)
SAVE
The SAVE command saves the contents of a controller’s flash in a
UFI file. The name of the UFI file is based on the controller type
and cannot be changed.
You must restart the computer following a SAVE command.
Command Syntax
The command syntax for the SAVE command is as follows:
AFU SAVE [/C
Command Switches
The following switches are available:
■
/C
the set of controllers on which to perform the specified
command. The default is 0, which means that if the computer
has multiple controllers, the AFU defaults to controller 0 unless you
specify otherwise.
You can specify a single controller ID, for example:
/C 0
multiple IDs separated by commas, for example:
/C 0,2
or ALL to indicate all controllers.
Note:
If the controller you want using the e /C switch;
otherwise, the AFU displays an error message and exits.
■
/D
specifies the path (drive and directory)
where the UFI files are located. If you do not specify the /D
switch, the AFU looks for, or creates, its UFI files in the default
location.
Note:
You cannot specify the name of a UFI file, only its path.
UFI filenames are predefined, based on the controller type.