Adaptec SATA AND SCSI RAID CONTROLLERS User Manual
Page 101
C-8
Adaptec Flash Utility (AFU)
VERIFY
The VERIFY command compares the contents of each of the flash
components on a controller to the corresponding image in a UFI
file and indicates whether they match. Use this command to
determine whether a controller’s flash components are up-to-date
when compared to a specific UFI file.
After using the VERIFY command, you must restart the computer
upon completion of this command.
Command Syntax
The command syntax for the VERIFY command is as follows:
AFU VERIFY [/C
Command Switches
For details on the /C and /D switches, see the
command on
Example
The following example shows a typical display resulting from a
verify operation.
A:\> AFU VERIFY /C 0
Adaptec Flash Utility V4.0-0 B5749
(c)Adaptec Inc. 1999–2002. All Rights Reserved.
Reading flash image file (Build 5748)
Controller #0: Adaptec 2410
ROM: Checksum: 797B [VALID] (Build 5748)
File: Checksum: 797B [VALID] (Build 5748)
Image Compares Correctly
VERSION
The VERSION command displays version information about the
flash components on a controller.
After using the VERSION command, you must restart the computer
upon completion of this command.
Command Syntax
The command syntax for the VERSION command is as follows:
AFU VERSION [/C
Command Switches
For details on the /C switch, see the
command on
.