Adaptec SATA AND SCSI RAID CONTROLLERS - Manual (Page 98)

C-5
Adaptec Flash Utility (AFU)
Running the AFU from the Command Line
At the DOS command prompt (typically A:\> ), type AFU followed
by a command and any switches. The AFU processes the
command, prompts you to insert additional floppy disks as
needed, exits, and reports success or an error message code.
Command Summary
This section describes each of the AFU commands in detail. The
commands appear alphabetically.
HELP
The HELP command displays a summary of AFU functions and
command switches.
Examples
The following are examples of command syntax that will work to
get help:
A:\> AFU HELP
A:\> AFU /?
LIST
The LIST command displays the AFU-supported controllers
installed on your computer. Use this command to see which
controllers are installed on this system, or to identify the ID
numbers assigned to each physical controller.
You do not have to restart the computer upon completion of this
command.
Example
The following example shows typical system output in response to
a LIST command.
A:\> AFU LIST
Adaptec Flash Utility V4.0-0 B5749
(c)Adaptec Inc. 1999–2002. All Rights Reserved.
Controllers Detected and Recognized:
Controller #0 (03:05:00) Adaptec 2410