Adaptec SATA AND SCSI RAID CONTROLLERS - Manual (Page 132)

D-29
Command Line Interface
Switches
/always —Specifies whether to initialize the disk even if the disk
has existing data. (Cannot override open files.) The default is
FALSE.
/unconditional —Specifies whether to initialize the disk even if
arrays on the disk have open files. The default is FALSE.
disk list [/all={boolean}] [/full={boolean}] [{device_ID}]
Lists the disks available on the controller.
Parameters
{device_ID} —ID number of the device to display information.
Switches
/all —List of all devices on the controller.
/full —Detailed information for devices. The default is FALSE.
disk remove dead_partitions {device_ID}
Removes all failed partitions from a disk.
Parameters
{device_ID} —ID number of the device from which to remove
failed partitions.
disk set default {device_ID}
Sets the default ID for use in CLI commands.
Parameters
{device_ID} —ID number of the device.
disk set smart [/all={boolean}] [/clear={boolean}]
[/enable_exceptions={boolean}][/logerr={boolean}]
[/perf={boolean}] [/report_count={boolean}]
[{device_ID}]
Changes a disk’s Self-Monitoring, Analysis and Reporting
Technology (SMART) configuration.
Parameters
{device_ID} —ID number of the device on which to change
SMART configurations.