Displaying array information, Displaying array information d-12 – Adaptec SATA AND SCSI RAID CONTROLLERS User Manual
Page 115
D-12
Command Line Interface
Disk Show Defects
The disk show defects command shows the following types on
information:
■
Total number and location of primary defects (defects that
originate during manufacturing)
■
Total number and location of grown defects (defects that
originate after manufacturing)
Example
In the example below, the drive contains five primary defects and
no grown defects:
AAC0> disk show defects /full=true (0,1,0)
Executing: disk show defects /full=TRUE (CHANNEL=0,ID=1,LUN=0)
Number of PRIMARY defects on drive: 5
Defect 1 at cylinder 229, head 7, sector 203
Defect 2 at cylinder 575, head 0, sector 219
Defect 3 at cylinder 576, head 0, sector 55
Defect 4 at cylinder 578, head 0, sector 238
Defect 5 at cylinder 579, head 0, sector 74
Number of GROWN defects on drive: 0
Disk Verify
The disk verify command shows the following types on
information:
■
Total number and location of primary defects (defects that
originate during manufacturing)
■
Total number and location of grown defects (defects that
originate after manufacturing)
Displaying Array Information
The CLI allows you to display and manage array attributes using
the following commands:
■
■
Container List
The container list attributes are defined as follows:
■
Drive Letter
—Letter associated with an array. Not
automatically assigned when you create an array.