Nilfisk-ALTO RS 2200 User Manual
Page 133
USER MANUAL
ENGLISH
RS 2200
33019476(3)2010-02 A
11
Consultation of B_BOX
•
(7, Fig. J), where all the
alarms occurred after the last memory reset are stored.
The alarm is identifi ed by a number code that can be
displayed as shown below: repeatedly press the upper
part of the push-button (23, Fig. E) until “MAIN MENU”
appears. Confi rm by pressing the lower part of the
push-button (23, Fig. E). The arrow cursor (1, Fig. J)
will be placed near the word “STATUS”. Press the lower
part of the push-button (23, Fig. E) again to bring the
arrow cursor near the word “MAINTENANCE”. Confi rm
by pressing the upper part of the push-button (23, Fig.
E). On the display (32, Fig. E) the page “MAINT.01”
is shown; when pressing the upper part of the push-
button (23, Fig. E) again, the page “MAINT.02” is
shown. When pressing the lower part of the push-
button (23, Fig. E), the cursor aligns with B_BOX,
then enter the B_BOX by pressing the upper part of
the push-button (23). In this page, the fi rst series of
numbers (33, Fig. J) indicates the alarm identifi cation
number, while the second series of numbers (34)
indicates the time at which the alarm occurred. The
stored alarms are up to 16 displayed on four pages,
which can be scrolled by pressing the push-button
(23, Fig. E) repeatedly. The alarms shown are both
instrument inner alarms and CAN-BUS transmission
line inner alarms indifferently.
CAUTION!
In the B_BOX the alarms are stored one
after the other, so when the alarms are
detected, always check for the time at
which the alarm occurred to have a real
chronology of the alarms.
Machine layout description
(See Fig. F)
Fuel tank
1.
Right front water tank
2.
Right rear water tank
3.
Steering cylinder
4.
Right rear drive wheel
5.
Right front wheel
6.
Hopper
7.
Right side water tank drain plug
8.
Fuel tank fi ller cap
9.
Engine air fi lter
10.
Drive system pump
11.
Turbine pump
12.
Accessory pump
13.
Battery hygrometer
14.
Condenser electric fan
15.
Right front water tank lower fastener
16.
Right front water tank upper fastener
17.
Battery
18.
Hydraulic system oil tank drain plug
19.
Hand pump lever
20.
Compressor
21.
Coolant drain hose
22.
Dust control system pump fi lter
23.
Climate control system condenser
24.
Frame number
25.
Suction inlet-hopper branch pipe
26.
Suction fan assembly
27.
Hand pump
28.
Radiator fan motor
29.
DPF differential Pressure Sensor
30.
Vacuum modulators
31.