Canon imagePROGRAF iPF6450 User Manual
Page 983
•
If the paper is jammed by the Ejection Guide
Remove the jammed paper from the Output Tray.
After removing the paper, make sure there are no oth-
er scraps of paper in the printer.
Note
•
If the Spectrophotometer Unit (optional) is mounted, then if the Up-down Unit of the Spectrophotometer Unit
(optional) is lowered, raise the Up-down Unit before removing the paper.
When the Up-down Unit is raised, handle the central part (near the blue label). Handling the ends may cause
damage.
•
If paper is jammed in the back of the printer
Remove the jammed paper from the back of the print-
er.
After removing the paper, make sure there are no oth-
er scraps of paper in the printer.
3
Press the OK button.
Cut sheets cannot be pulled out from the front paper feed slot
Cut sheets cannot be pulled out from the front paper feed slot
Cause
Corrective Action
You have loaded
paper other than
POP board.
Push the cut sheet from the front side of the printer towards the back side. Once the edge of the cut sheet protrudes from
the back side of the printer, pull it out from the back side.
iPF6450
Cut sheets cannot be pulled out from the front paper feed slot
Troubleshooting
Problems Regarding Paper
983