Eject – Canon imagePROGRAF iPF6450 User Manual
Page 547
Cutting Method
Printer Setting
Driver Setting
To cut the roll with the Cutter Unit, press the Cut but-
ton.
Media
Menu > Pa-
per Details
> (Various
Types of
Paper) >
Cutting
Mode
Auto Cut
(See "Cut-
ting Roll Pa-
per After
Printing.")
Eject
Yes
Choose this setting when using media that cannot be
cut using the Cutter Unit.
Use scissors to cut each document from the roll after
printing. For continuous printing (if you will cut each
page later), select Auto Cut > Yes or select Print Cut
Guideline.
Manual
No Yes Print Cut
Guideline
Choose this option if you want to cut pages by pressing
Cutter Unit buttons for manual cutting after printing
when Auto Cut > No is selected or Print Cut Guide-
line is selected in the printer driver.
Otherwise choose this option if you want to cut the roll
edge after loading a roll.
Cut button
pressed
Yes
No Print Cut
Guideline
Note
•
Automatic and Eject are valid only when you have selected Auto Cut > Yes in the printer driver.
•
With Eject, printing does not resume after a series of jobs have been printed continuously until the roll is cut.
•
Eject is the preset selection in Cutting Mode for some types of paper. For this paper, we recommend keeping the preset
cutting mode.
•
If documents printed using Automatic, Eject, or manual cutting are short, rolls are advanced a specific amount before cutting
to prevent problems with cutting and paper ejection. This may create a wider bottom margin, in some cases.
Cut rolls manually in the following cases:
Eject (when the paper surface is being scratched / to wait for ink to dry)
Important
•
When cutting wide printed documents after ejection, have two people support the documents. If the paper drops, printed
documents may be damaged.
•
Do not lift the paper when holding printed documents before cutting. If the paper rises, it may affect the printing quality or
cause rough cut edges.
1
On the Tab Selection screen of the Control Panel, press
◀ or ▶ to se-
lect the Paper tab (
).
iPF6450
Specifying the Cutting Method for Rolls
Handling and Use of Paper
Handling rolls
547