Canon PowerShot SX50 HS - Manual (Page 176)

176
Protecting Images
2
Choose an image.
z z Press the < q> buttons or turn the
< 5> dial to choose an image, and then
press the < m> button. [ ] is displayed.
z z To cancel selection, press the < m>
button again. [ ] is no longer displayed.
z z Repeat this process to specify other
images.
3
Protect the image.
z z Press the < n> button. A
confirmation message is displayed.
z z Press the < q> buttons or turn the
< 5> dial to choose [OK], and then press
the < m> button.
• Images will not be protected if you switch to Shooting mode or turn
the camera off before finishing the setup process in step 3.
Selecting a Range
1
Choose [Select Range].
z z Following step 2 on = 175, choose
[Select Range] and press the < m>
button.
2
Choose a starting image.
z z Press the < m> button.
COP
Y