Canon imagePROGRAF iPF9400 - Manual (Page 912)

Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print sheet
or other printer status information.) The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
"Replace roll with 10 in. wide or larger roll."
Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print sheet or other print-
er status information.) Replace the roll with a roll 10 inches in width or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
→P.539
(See "Removing the Roll Holder from Rolls.") →P.542
2. Replace the roll with a roll 10 inches wide or larger.
(See "Attaching the Roll Holder to Rolls.")
→P.530
(See "Loading Rolls in the Printer.") →P.533
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
PaprWidth Mismatch PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is set to
Pause or Hold Job, the width of the loaded roll does not
match the width specified in Fit Roll Paper Width in the print-
er driver. Press ▲ or ▼ to select Print, and then press the OK button to resume print-
ing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
1. Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
→P.539
(See "Removing the Roll Holder from Rolls.") →P.542
2.
Replace with paper of the width configured in the printer driver.
(See "Attaching the Roll Holder to Rolls.")
→P.530
(See "Loading Rolls in the Printer.") →P.533
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
Paper size not detected. Paper size not detected.
Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. Lift up the Release Lever and reload the paper.
(See "Loading Rolls in the Printer.")
→P.533
(See "Loading Sheets in the Printer.") →P.555
If "Not finished printing. Finish printing re-
maining jobs?" is displayed on the Display
Screen, press the OK button.
Printing will resume, starting from the page on
which the error occurred.
PaprWidth Mismatch iPF9400
User's Guide
Error Message
Messages regarding paper
912