Brother PT-E300 - Manual (Page 43)

1
2
3
4
5
6
7
8
9
40
z
EDIT
ING A LA
BEL
Setting Cut Options
Selecting how tape is fed and cut
When printing, the message "Cut Tape or Press Enter to Continue" is displayed and goes
into [cut pause mode]. Pressing the Tape cutter lever, you can cut the tape at the position
you set in "Cut Option". The details are as follows.
• :Stop here and goes into [cut pause mode].
• :Stop here and finish printing.
• :Stop here and goes into [tape feed mode].
• When using Heat Shrink Tube, set labeling application type to "Cable Wrap" and select "Heat-
shrink Tube". In this case, cut option if fixed to "No Cut". After printing, remove the Heat Shrink
Tube cassette from the labeling system and use scissors to cut the tape.
• After printing, remove the Fabric Iron On tape cassette from the labeling system and use scissors
to cut the tape.
Small Margin Chain
Large Margin No Cut
When the cut option is set to No Cut or Chain, it stops in the middle of printing area after the last
label is printed. After "OK to Feed?" is displayed, press OK key to feed tape. Press Escape key
to return to the entering text mode.