Brother PT-E300 - Manual (Page 27)

1
2
3
4
5
6
7
8
9
24
z
GET
T
IN
G S
T
ARTED
Turning Power On/Off
Close the rear cover.
Press the Power key to turn the P-touch labeling system on.
Press the Power key again to turn the P-touch labeling system off.
z Auto Power-Off Time z
Feed function
The Feed function feeds 0.91" (23 mm) of blank tape.
Press the Shift key and then press the Preview key.
The message "Feeding Tape... Please Wait" appears while the tape is fed.
4
• Do not pull the label coming out of the tape exit slot. Doing so will cause the ink ribbon to
be discharged with the tape.
• Store tape cassettes in a cool dark location, away from direct sunlight and high temperature, high
humidity, or dusty locations. Use the tape cassette as quickly as possible after opening the sealed
package.
Extra Strength Adhesive Tape:
• For textured, rough, or slipping surface, we recommend using Extra Strength Adhesive Tape.
• Although the instruction sheet included with the Extra Strength Adhesive Tape cassette
recommends cutting the tape with scissors, the tape cutter that this P-touch labeling
system is equipped with is able to cut Extra Strength Adhesive Tape.
Turning Power On/Off
• Your P-touch labeling system has a power saving function that automatically turns itself off if
no key is pressed within a certain time and operating conditions. Refer to the Auto Power-Off
Time table below for details.
• If the batteries are installed or the P-touch labeling system is connected to an electrical outlet by
the AC adapter, the previous session's information is displayed when the power is turned on.
With AC adapter 5 minutes
With battery 5 minutes
Feeding Tape
• Do not pull the label coming out of the tape exit slot. Doing so will cause the ink ribbon to
be discharged with the tape.
• Do not block the tape exit slot during printing or when feeding tape. Doing so will cause the tape
to jam.
1
2