Brother PT-E300 - Manual (Page 42)

EDITING A LABEL
39
Setting Cut Options
The tape cutting options allow you to specify how the tape is fed and cut when printing labels.
In particular, the “Chain” option greatly reduce the amount of wasted tape by using smaller
margins and eliminating blank sections cut between labels. Depends on labeling application
type, the setting value is fixed or limited.
Press the Style key to display the Label menu.
Select "Cut Option" using the or key, and then set the value
by using the or key.
Press the OK or Enter key to apply the settings.
z Tape Cutting Options z
Setting Cut Options
1
2
3
New settings are NOT applied if you do not press the OK or Enter key.
• Press the Escape key to return to the previous step.
• Refer to the Tape Cutting table for a list of all available settings.
Setting Description Example
Large
Margin
• Each label is printed, leaving a margin of 0.94"
(24 mm) on each end.
Small
Margin
• A margin of 0.91" (23 mm) is fed before printing
each label. The printed label has a margin of 0.16"
(4 mm) before and after the text.
Chain
• Use this setting when printing several labels with
minimum margins.
• A margin of 0.91" (23 mm) is printed first, and
then each label is printed, leaving a margin of
0.16" (4 mm) before and after the text.
No Cut
• Use this setting when printing Heat Shrink Tube.
• Pressing the Shift key and then the Preview key
feeds the last printed label and cut it.
ABC
0.94" (24 mm)
0.94" (24 mm)
ABC
0.16"
(4 mm)
0.16"
(4 mm)
0.91" (23 mm)
ABC ABC
0.16"
(4 mm)
ABC
0.16"
(4 mm)
0.94" (24 mm)