Brother PT-2100 - Manual (Page 73)

1
2
3
4
5
6
7
8
9
67
z
TRO
U
BLESHOOTING
Error Messages
A 1/4" (6 mm) tape cassette is not installed when an Auto-
Format for 1/4" (6 mm) tape is selected. Install a 1/4" (6 mm)
tape cassette.
A 9/64" (3.5mm) tape cassette is not installed when an Auto-
Format for 9/64" (3.5mm) tape is selected. Install an 9/64"
(3.5mm) tape cassette.
The maximum number of characters for the selected layout
have already been entered. Edit the text to use fewer
characters or use a different layout.
The value entered for setting the tape length, tab length,
multiple copies, or numbering function is invalid. Enter a valid
value for the setting.
The tape length set using the tape length setting is shorter than
the total length of the left and right margins applied for the
"Large Margin" cutting option. Select a different cutting option.
The length of the label to be printed using the text entered is
longer than the length setting. Edit the text to fit within the set
length or change the length setting.
The text size is too large. Select a different size option.
The number of digits entered in the bar code data does not
match the number of digits set in the bar code parameters.
Enter the correct number of digits.
The bar code data entered does not have the required start/
stop code (A, B, C, or D required at the beginning and end of
the bar code data for the CODABAR protocol). Enter the bar
code data correctly.
There are already 5 bar codes entered in the text data when
you try to enter a new bar code. You can only use up to five
bar codes in each label.
Message Cause/Remedy