Brother PT-2100 - Manual (Page 24)

18 Power Supply
GETTING STARTED
AC Adapter
Connect the AC adapter directly to the P-touch labeler.
Insert the plug on the AC adapter cord into the connector marked DC IN 9-9.5V
on the P-touch labeler.
Insert the AC adapter plug into a standard electrical outlet.
Remove the batteries if you do not intend to use the P-touch for an extended period of time.
1
2
• Turn the P-touch labeler off before disconnecting the AC adapter.
• Do not pull or bend the AC adapter cord.
To safe guard and backup the labeler's memory, when the AC adapter is unplugged it is
recommended to have AA-size alkaline batteries (LR6) installed into the machine.
WARNING
• Use only the adapter (AD-24), which is designed exclusively for your P-touch.
Failure to observe this may result in an accident or damage. Brother shall not
assume any responsibility for any accident or damage resulting from not using the
specified AC adapter.
• Do not connect the AC adapter to a non-standard electrical outlet. Failure to
observe this may result in an accident or damage. Brother shall not assume any
responsibility for any accident or damage resulting from not using a standard
electrical outlet.
CAUTION
• Disconnect the AC adapter from the P-touch and electrical outlet when you do not
intend to use the P-touch for an extended period.
• When power is disconnected for more than two minutes, all text and format settings
will be cleared. Any text files stored in the memory will also be cleared.