Brother PT-2600 - Manual (Page 101)

94
EXAMPLE
Although the length of the printed label automatically adjusts to fit the length of the entered
text, there may be times when you will want to make a label with a specific length. The Length
function allows you to set the label length between 1.6” and 11.8” (4.0 cm and 30.0 cm).
The default length setting is OFF. When the Length function is set to ON, the Length indicator
on the right side of the display comes on.
☞
The label length setting is only applied to labels printed on TZ tape. The label
length of AV labels cannot be adjusted.
To turn the Length function on or off:
1 While holding down c, press T once, and keep c held down to display the cur-
rent length of the label (the text and both margins). Then, the display will show the cur-
rent label length setting (ON or OFF).
2 While still holding down c, continue pressing T until the desired label length setting
is displayed.
☞
The Length indicator comes on when ON is selected.
3 Release c. If ON was selected, the current label length setting is displayed.
4 Press e or h to select the desired length or use the number keys to enter a length.
☞
To change the units (inches or centimeters) used to display the label length, press
M until the desired units are displayed.
To change the length in 1” (1.0-cm) steps, hold down either
e or h, and then
release the key when the desired setting is displayed.
To select the ON mirror printing setting:
1 While holding down
c
, press
p
once, and
keep
c
held down.
2 While still holding down
c
, continue pressing
p
until ON is displayed.
3 Release
c
.
O F F
M I R R O R
A B C
O N
M I R R O R
A BC
LENGTH FUNCTION
TZ-T
ape
AV
-Label