Brother PT-H300 - Manual (Page 26)

20 Power Supply
GETTING STARTED
Using the Rechargeable Li-ion Battery (BA-E001: Optional on the PT-H300)
„ Installing the Rechargeable Li-ion Battery
Open the rear cover by pressing the cover latch.
Insert the rechargeable Li-ion battery into the battery
compartment.
Confirm that the hooks on the edge of the rear cover are inserted correctly, and then
reattach the cover.
Removing the Rechargeable Li-ion Battery
Remove the battery cover and the rechargeable Li-ion battery, and then reattach the battery
cover.
„ Charging the Rechargeable Li-ion Battery
The rechargeable Li-ion battery can be charged while it is inserted in the labeler. Perform
the following procedure to charge the rechargeable Li-ion battery.
Make sure that the labeler is turned off. If the labeler is turned on, press the (Power)
button to turn it off.
Make sure that the rechargeable Li-ion battery is installed in the labeler.
Use the AC adapter and AC power cord to connect the labeler
to an AC power outlet.
The LED next to the adapter connector turns on during
charging, it goes off when the rechargeable Li-ion battery is full
charged. The battery level indicator on the display will fill in with
three bars
.
Cover latch
Rear cover
1
2
3
• Before using the rechargeable Li-ion battery, use the following procedure to charge it.
• Up to 360 minutes is needed to fully charge a rechargeable Li-ion battery.
1
2
3