Brother PT-H300 - Manual (Page 14)

INTRODUCTION
8
Safety Precautions
CAUTION
Alkaline batteries/Ni-MH rechargeable batteries
Follow these guidelines to avoid liquid leakage, overheating or rupture of the battery.
DO NOT use a battery other than the
one specified for use with your printer.
Do not use combinations of old and new
batteries or combinations of different
types, different charging levels, different
manufacturers or different models. Do
not insert a battery with the polarity (+
and -) reversed.
If fluid leaked from the battery gets on
your skin or clothes, immediately rinse
them with clean water.
Remove the batteries if you do not
intend to use the P-touch labeler for an
extended period of time.
Before using Ni-MH rechargeable
batteries, carefully read the instructions
for the batteries and battery charger, and
be sure to use them correctly.
When using Ni-MH rechargeable
batteries, charge the batteries with the
appropriate, specialized battery charger.
Before using the batteries.
DO NOT disassemble or modify the
batteries.
DO NOT expose the batteries to heat or
dispose of the batteries in a fire.
AC Adapter
If you do not intend using the P-touch
labeler for an extended period of time,
disconnect the AC adapter from the
power outlet.
When disconnecting the AC adapter
from the power outlet, always hold the
AC adapter.
DO NOT use the AC adapter in places of
high humidity such as bathrooms.
DO NOT overloading electrical circuit
the power cord.
DO NOT disassemble or modify the AC
adapter.
DO NOT allow the AC adapter/power
plug to get wet, for example, by handling
them with wet hands or spilling
beverages on to them.
Tape Cutter
Follow these guidelines to avoid minor personal injury and damage to the labeler.
DO NOT open the tape compartment
cover when operating the cutter unit.
DO NOT apply excessive pressure to
the cutter unit.