Brother DCP-395CN - Manual (Page 20)

Chapter 1
8
Basic Operations
1
The following steps show how to change a
setting in the machine. In this example the
Paper Type setting is changed from
Plain Paper to Inkjet Paper.
a
Press Menu.
b
Press a or b to choose
General Setup.
Press OK.
c
Press a or b to choose Paper Type.
d
Press d or c to choose Inkjet Paper.
Press OK.
You can see the current setting on the
LCD:
e
Press Stop/Exit.
Status LED indications
1
The Status LED (light emitting diode) is a light
that shows the status of the machine, as
shown in the table.
MENU
Network Network
Machine Info. Machine Info.
Initial Setup
Initial Setup
Print Reports Print Reports
Select & Press OK
General Setup
General Setup General Setup
MENU
Paper Type Paper Type
Paper Size Paper Size
Inkjet Paper Inkjet Paper
Letter Letter
5 Mins Mins
LCD Settings LCD Settings
Sleep Mode Sleep Mode
Select & Press OK
LED DCP status Description
Off
Ready The DCP is ready for
use.
Orange
Cover open The cover is open. Close
the cover. (See Error
and Maintenance
messages on page 80.)
Cannot Print Replace the ink cartridge
with a new one. (See
Replacing the ink
cartridges on page 87.)
Paper error Put paper in the tray or
clear the paper jam.
Check the LCD
message. (See Error
and Maintenance
messages on page 80.)
Other
messages Check the LCD
message. (See Error
and Maintenance
messages on page 80.)