Brother MFC-3240C - Manual (Page 113)

USING THE PHOTOCAPTURE CENTER ™ FROM YOUR PC 6 - 3
For Network cable users
1
Insert a SmartMedia
®
, CompactFlash
®
, Memory Stick
®
,
SecureDigital
™
or xD-Picture Card
™
into your machine.
2
Double-click the Network PhotoCapture Centre icon.
3
Your browser software will appear and a list of file names on
your media card will be shown.
4
Click the file name you wish to see.
When you take out a media card, do the following to prevent damage
to the media card:
5
Close the browser.
6
Wait until the PhotoCapture button stops blinking before taking
out the media card.
If more than two media cards are inserted at the same time, the
PhotoCapture Center
™
will read only the card that was put in
first. To have access to another card, you must first take out all
the cards, and then put in the media card you wish to access.
Your browser software accesses the media card using FTP and
the network Host Name of the machine. You can open the
software by entering ftp://XXX.XXX.XXX.XXX (Where
XXX.XXX.XXX.XXX is the IP address of your Brother machine).
Do NOT unplug the power cord, or remove a SmartMedia
®
,
CompactFlash ® , Memory Stick ® , SecureDigital ™ or xD-Picture
Card
™
from the machine while it is reading the card
(PhotoCapture button flashing). You could lose your data or
damage the card.
If you took out the media card while PhotoCapture button was
flashing, you must immediately restart your PC before putting
the media card back in. If you put in another media card before
the PC is restarted, the data on it may be destroyed.