Brother TD-4100N - Manual (Page 83)

ESC i M 2D bar code MaxiCode control
[ASCII] ESC i M or m data
[Decimal] 27 105 77 or 109 data
[Hexadecimal] 1B 69 4D or 6D data
• Format
ESC i M or m [Parameters]
\
[Bar code data]
\\\
1 2 3 4
① Parameters
If a value other than those listed is entered for a parameter, that parameter is set to its
default value.
1. Symbol type
[Decimal 1 byte] 0
[Decimal 1 byte] 1
[Decimal 1 byte] 2
Standard (default
value)
Full EEC
Structured carrier message
2. Append mode
[Decimal 1 byte] 0
[Decimal 1 byte] 1
Structured append (default value)
Not appended
②
\
Separator between parameters and bar code data
③ Bar code data
The number of bar code data that can be entered is listed below.
Maximum amount of information allowed Symbol type
Alphanumeric characters Numbers
Standard 93 138
Full EEC 77 113
Structured carrier message 84 126
*Notes:
The numbers of characters that can be entered (as listed above) are for when using only
the common character set (code set A in the MaxiCode specifications). The number of
characters that can be entered may decrease, depending on the characters that are used.
83
When the symbol type is the structured carrier message, the service class, country code
and postal code can be specified separately from the normal data. Specify each value,