Brother TD-4100N - Manual (Page 78)

8. Aspect value
[Decimal 2 bytes] 1–1000
Inputs the aspect value. Actually, this is 0.01–10.0, but
since the decimal point can not be entered, 100x the value
is entered.
The default value is 50. (Actual value of 0.5)
*Notes:
-
When the Symbol size X specification or the symbol size specification is input, Aspect
value is ignored.
- When the Symbol size X specification or the symbol size specification is input,
sometimes bar cord is not printed or unreadable barcode is printed.
-
If both large cell size and high level error correction capacity is specified, it may not
print because of over print buffer.
[With symbol type MicroPDF417]
- Since the error correction capacity is automatically determined from symbol size X
specification, the settings for “Error correction capacity and type” and “Error correction
capacity and value” are ignored.
-
The aspect value setting is ignored.
The following table shows the values available for symbol size Y specification according
to symbol size X specification. If an invalid setting is specified for symbol size Y
specification, the default setting is specified.
Symbol size X
specification
Symbol size Y specification
AUTO AUTO
1 AUTO 11 14 17 20 24 28
2 AUTO 8 11 14 17 20 23 26
3 AUTO 6 8 10 12 15 20 26 32 38 44
4 AUTO 4 6 8 10 12 15 20 26 32 38 44
2
Bar code data
The numbers of bar code data items that can be input are as follows.
1850 alphanumeric characters, 2710 numbers, 1108 binary bytes
*Note: The numbers shown here is for high-density Level L 7% of Error correction level. If
you specify them on more than standard lebel, the number may decrease. And, even if you
78
Specify then on high-density level, it may decrease because of the treatment of
compression.