Brother Innov-is V5 - Manual (Page 51)

UPPER THREADING
G
ettin
g R
ea
d
y
Basic operations B-49
B
1
h
Continue threading however do not pass
the thread in the needle bar thread guide
“6” on the needle bar. Thread the needle on
the right side.
a Needle bar thread guide
i
Press .
j
Select a stitch pattern. (Example: )
* Refer to the “STITCH SETTING CHART” on
page S-67 for the proper stitch to use with presser
foot “J”.
→ The selected stitch is displayed.
k
Press to select the twin needle mode.
a Single needle/twin needle setting
→
appears.
l
Start sewing.
Sample of Twin Needle Sewing
Using Threads that Unwind
Quickly
■ Using the Spool Net
If using transparent nylon monofilament thread,
metallic thread, or other strong thread, place the
included spool net over the spool before using it.
When using specialty threads, threading must be
done manually.
If the spool net is too long, fold it once to match it to
the spool size before placing it over the spool.
Note
• If the key is light gray after selecting
the stitch, the selected stitch cannot be
sewn in the twin needle mode.
CAUTION
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
a
Memo
• To change direction when sewing with the
twin needle, raise the needle from the
fabric, raise the presser foot lever, and then
turn the fabric.
a Spool net
b Thread spool
c Spool pin
d Spool cap
Memo
• When threading the spool with the spool net
on, make sure that 5 cm - 6 cm (approx.
2 inches - 2-1/2 inches) of thread are pulled
out.
• It may be necessary to adjust the thread
tension when using the spool net.