Brother Innov-is V5 - Manual (Page 27)

LCD SCREEN
G
ettin
g R
ea
d
y
Basic operations B-25
B
1
General settings
a Select the needle stop position (the needle position when the machine is not operating) to be up or down. Select
the down position when using the pivot key. (see page S-15)
b Select the operation of the “Needle Position – Stitch Placement” button from the following two sequences (see
page S-18).
Each press of the “Needle Position – Stitch Placement” button:
“ON” – raises the needle, stops it at a nearly lowered position, then lowers it
“OFF” – raises the needle, then lowers it
c Change the shape of the pointer when a USB mouse is used (see page B-28).
d Turn the “Upper and Bobbin Thread Sensor” “ON” or “OFF”. If it is turned “OFF”, the machine can be used without
thread. (see page S-4, E-26)
e Change the speaker volume. Increase the number for louder volume, decrease for softer volume.
f Select to save the machine power by setting the “Eco Mode” or the “Shutoff Support Mode” (see page B-28).
g Select the initial screen that is displayed when the machine is turned on (see page B-28).
h Change the display language (see page B-29).
CAUTION
• If “Upper and Bobbin Thread Sensor” is set to “OFF”, remove the upper thread. If the machine is used
with the upper thread threaded, the machine will not be able to detect if the thread has become tangled.
Continuing to use the machine with tangled thread may cause damage.
a
d
e
b
c
g
h
f