Brother RJ-4030 User Manual
Software developer's manual
This manual is related to the following products:
Table of contents
Document Outline
- IMPORTANT - PLEASE READ CAREFULLY
- Introduction
- About Raster Commands
- 1. Printing Using Raster Commands
- 2. Print Data
- 3. Print Command List
- 4. Printing Command Details
- NULL Invalidate
- ESC i S Status information request
- ESC @ Initialize
- ESC i U Additional media information command
- ESC i d Specify margin amount (feed amount)
- ESC i a Switch dynamic command mode
- g Raster graphics transfer
- ESC i B Specify baud rate
- Z Zero raster graphics
- FF Print command
- Control-Z Print command with feeding
- ESC i z Print information command
- M Select compression mode
- 5. MCR Command Specifications
- 6. Flow Charts
- 6.1 Normal flow for USB connection
- 6.2 Error flow for USB connection (when feeding at the end of the page)
- 6.3 Error flow for USB connection (with a concurrent printing error such as end of tape)
- 6.4 Cooling flow for USB connection
- 6.5 Flow for setting serial connection baud rate
- 6.6 Normal flow for serial connection
- 6.7 Error flow for serial connection
- 6.8 Cleaning flow for serial connection
- Appendix A: USB Specifications
- Appendix B: Introducing the Brother Developer Center