Sterlco SSL and SSIL Series Hopper Loaders - Manual (Page 36)

36
Adjusting Proportioning On the Fly During Operation
1. While the hopper loader is operating, press the
SCROLL
SCROLL key
until the screen displays the percent of Material B as P. nn.
2. Press the UP key or the DOWN key to change the value
as needed.
3. When the percentage of Material B you want displays, press the
S
START/STOP
START/STOP/ SELECT/SET key to set it.
- or -
Press the
SCROLL
SCROLL key to leave the menu unchanged.
The screen then displays the Vacuum Timer menu.
Note: “On-the-fly” adjustments range between 1% and 99%. To set the
percentage of Material B from 0% to 100%, stop the Series One
Plus controller and reset proportioning while the unit is in
Standby mode, as described in the previous section.
5-7 Using the Batch Counter
The Series One Plus controller features a batch counter you can view during operation. The
batch counter provides a rough approximation of total material throughput.
Viewing the Batch Counter
While the hopper loader is operating and while the screen displays the vacuum timer display:
„ Press the
SCROLL
SCROLL key until the screen displays the four-digit
batch counter.
The screen remains on the batch count display until you press the
SCROLL
SCROLL key again.