Sterlco SDAP 90-225 CFM Series Drying and Conveying Systems - Manual (Page 64)

Page 64 SDAP Series PD 2 to PD 4 Drying and Conveying Systems
Figure 19
Setting List for Dew Point Controller Part No. A0548567 Cont’d.
Mode Parameter Setting range Default AEC setting
Setup Cn-t Input Type 0 to 21 2 17
Setup Cn-H Scaling Upper Limit
Scaling Lower Limit +1 to
9999 EU
-100 15
°F/-9C
Setup Cn-L Scaling Lower Limit
-1999 to SP Setting Upper
Limit –0.1 EU
0 -40
°F/-40C
Setup dP Decimal Point 0 to 3 0 Default
Setup CnCE Parameter Initialize Yes/No No Default
Setup
6Ut1 Control Output 1
Assignment
Heat/Cool/Alarm 1/Alarm 2/
Alarm 3/LBA
Heat COOL
Setup
6Ut2 Control Output 2
Assignment
Heat/Cool/Alarm 1/Alarm 2/
Alarm 3/LBA
AL-1 Default
SetUp
Sub 1 Auxiliary Output 1
Assignment
Alarm 1/Alm 2/Alm 3/LBA/S.
ERR/E333
AL-2 Default
Setup ALt1 Alarm 1 Type 0 to 11 2 8
Setup AL1n Alarm 1 open in alarm NO/NC NO Default
Setup ALt2 Alarm 2 Type 0 to 11 2 8
Setup AL2n Alarm 2 open in alarm NO/NC NO Default
Setup
6rEU Direct/Reverse
Operation
OR-R/OR-D OR-R Default
Expansion SL-H Set Point Upper Limit
SP Lower Limit +1 to
Scaling Upper Limit
1300 15
°F/-9C
Expansion SL-L Set Point Lower Limit
Scaling Upper Limit to Sp
Lower Limit
-200 -40
°F/-40C
Expansion CntL PID/ON/OFF PID/ON-OFF PID ON-OFF
Expansion
rESt Standby Sequence
Reset Setting Method
0/1 0 Default
Expansion
rEt Automatic Return of
Display Mode
0 to 99 SEC 0 Default