Sterlco SDAP 90-225 CFM Series Drying and Conveying Systems - Manual (Page 61)

SDAP Series PD 2 to PD 4 Drying and Conveying Systems Page 61
Figure 18
Setting List for Process Temperature Controller, Part No. A0555756 Cont’d.
Mode Parameter Setting range Default AEC setting
Setup Cn-E Input Type 0 to 21 2 3
Setup Cn-H Scaling Upper Limit Scaling Lower Limit +1 to 9999 EU -100 Default
Setup Cn-L Scaling Lower Limit -1999 to SP Setting Upper Limit -0.1 EU 0 Default
Setup dP Decimal Point 0 to 3 0 Default
Setup d-U
°C/F Selection °C/F °C °F
Setup
CnCE Parameter
Initialize
Yes/No No Default
Setup
6UE1 Control Output 1
Assignment
Heat/Cool/Alarm 1/Alarm 2/Alarm 3/
LBA
Heat Default
Setup
6UE2 Control Output 2
Assignment
Heat/Cool/Alarm 1/Alarm 2/Alarm 3/
LBA
AL-1 Default
Setup
Sub 1 Auxiliary Output 1
Assignment
Alarm 1/Alm 2/Alm 3/LBA/S.ERR/E333 AL-1 Default
Setup ALE1 Alarm 1 Type 0 to 11 2 Default
Setup
AL1n Alarm 1 open in
alarm
NO/NC NO
Default
Setup ALE2 Alarm 2 Type 0 to 11 2 Default
Setup
AL2n Alarm 2 open in
alarm
NO/NC NO Default
Setup ALE3 Alarm Type 0 to 11 2 Default
Setup
AL3n Alarm 3 open in
alarm
NO/NC NO Default
Setup
6rEu Direct/Reverse
Operation
OR-R/OR-D OR-R Default