ROTRONIC HygroLab - Manual (Page 49)

IN-E-HyLab-V4_11
Rotronic AG
Bassersdorf, Switzerland
Document code Unit
Instruction Manual
Document Type
HygroLab bench top indicator version 4:
instruction manual
Document title
Page 49 of 51
© 2006; Rotronic AG IN-E-HyLab-V4_11
At the end of the dwell time, the display changes as follows:
0. 9 1 5
A w
2 4. 8 1 ° C
Q 1 0 0 : 0 4 : 0 0 R
Current
Aw projection
average
temperature
AwQuick mode no longer
in the dwell phase
When the projected value of Aw is stable, the HygroLab beeps once and freezes the display. Black
rectangles to the left of the display indicate that the measurement is ended.
0. 9 3 4
A w
2 4. 7 9 ° C
Q 1 0 0 : 0 4 : 5 0 S
Measurement ended
The AwQuick mode runs simultaneously for all probes connected to the HygroLab. When a probe
is done, the HygroLab beeps once and freezes the display for that probe. The display can be
manually switched to another probe from the keypad with the ▼ or ▲ arrow.
When the last probe is done, press the ENTER key to exit this screen and return to the standard
mode.
Press ENTER again to start a new measurement in the AwQuick mode with all probes.
Important: unlike the equivalent function of the HW4 software, the HygroLab 3 does not allow to
start and stop each probe individually. To avoid possible confusion, you may want to turn off any
unused probe either by disconnecting or turning off the probe.