beautypg.com

Appendix – NORD Drivesystems B2000 User Manual

Page 42

background image

6. Appendix

-42-

B2000-GB-0413

www.nord.com

X

NORDBLOC helical gear units SK072.1 and SK172.1

1. Bring the gear unit into the M2 installation orientation and remove the oil level screw for the

M2 orientation.

Figure 6-2: Bring the gear unit into the M2 installation orientation

2. Determine the measurement X between the upper edge of the gear unit housing and the oil

level. If necessary, adapt the dipstick (see below).

Figure 6-3: Measuring the oil level

3. Compare the determined measurement X with the corresponding measurement in the

following table. If necessary, adjust the oil level with the type of oil shown on the rating plate.

4. Screw in and tighten the oil level screw in the installation orientation M2 as per Section 4.1.

5. Bring the gear unit back into the installation orientation M4.

Danger!

Oil level check in the M4 installation orientation for SK072.1 and SK172.1:
The oil level check for the M4 installation orientation must be carried out as follows in
the installation orientation M2:

Gear unit type

Thread

size

Measurement

X [mm]

SK 072.1

M8x1

22 ± 1mm

SK 172.1

M8x1

20 ± 1mm

Upper edge of housing

Oil level