Hoyles AIDALARM Disabled toilet alarm Stainless Panic Strip Kit - Manual (Page 2)

Programming
All settings made in programming mode will be maintained in memory even if power is removed. The following features of the
system can be programmed.
a. Control panel button function
The control panel button is located below the power on LED. There are three possible options for this button. It can be used as
either a SILENCE button, a RESET button or be completely disabled. The factory default setting is SILENCE.
The default setting is probably adequate for most applications but if it needs to be changed proceed as follows: Move the
jumper on the PCB to the Set mode position. The LEDs on the PCB will flash indicating the current setting. (See table below)
Scroll through the three possibilities by pressing the small Set Button on the PCB. When finished either continue to set the tone
as in (b) below, or move the Set jumper back to the Use mode.
b. Control panel alarm tone
Whilst in Set mode (jumper on the PCB in the Set position), press the control panel button on the front of the panel to move into
tone setting mode, the LED will indicate steady. Repeatedly press the control panel button to scroll through the four different
tones. Pause for 2 seconds after each press and the selected tone will play for 2 seconds. The last tone played is the tone that
will be stored in memory. When the tone has been played the setup will revert to setting the control panel button function with
the LEDs flashing. When finished, move the Set mode jumper back to the Use mode.
Stainless Steel AIDALARMs and accessories are supplied as individual items or in kit form. Kit part numbers are:
A600FKITR (A600F AIDALARM controller, S1600 pull cord, S1708SR reset button and S1778SR overdoor light/buzzer)
A600FKITRD (A600F AIDALARM controller, S1600 pull cord, S1708SR reset button, S1778SR overdoor light/buzzer and
RPD01000 1m length of DADO Panic strip)
60130 Iss 1 June 2011 T. 01744 886600 F. 01744 886607 E. [email protected] W. www.hoyles.com
Hoyles Electronic Developments Ltd
Also available from Hoyles...
Battery Powered Toilet Alarm Kit - A600LKITB
Powered by 6 x AA alkaline batteries
No mains wiring
BS8300 and DDA compliant
6 Zone Toilet Alarm System - AA31110D
Powered by 6 x AA alkaline batteries
No mains wiring
BS8300 and DDA compliant
6 zone control panel providing central indication of calls.
Expandable
Repeater panels available
Requires 1 x pull cord (S1600), 1 x over door light / sounder S1778A
and 1 x reset button S1708A per zone (Available separately).
BS8300 and DDA compliant
S1600 S1778A S1778A
Button
Operation
Silence
Reset
Disabled LED
Flashing
LED1
LED2
LED3