FUTEK CSG110 (JM-2A / JM-2AD)-Series - Manual (Page 12)

12
DIP Switch 1: Excitation
• The Excitation is the voltage supplied from the
CSG110 to the sensor and can be 5 VDC or 10 VDC.
• It is recommended to use a higher excitation, if
applicable, as less gain will be needed which will
reduce noise.
DIP Switch 2: Polarity
• The polarity switch can be used to change the polari-
ty of the incoming signal to the CSG110.
• For example, if tension is negative it can be made
positive through DIP Switch 2.
DIP Switch Description
EXCITATION SW1
Position Excitation
▲ 5 VDC
▼ 10 VDC
POLARITY SW2
Position Polarity
▲ REVERSE
▼ STRAIGHT