FUTEK CSG110 (JM-2A / JM-2AD)-Series - Manual (Page 10)

10
1. The voltage output of the CSG110 is passed through
a current converting phase. This means the prior Ex-
citation and Gain setting steps of the voltage setup
must be performed first.
2. The configured voltage output will become the input
range for the current conversion phase. Using DIP
switches 5, 6, and 7, set the desired current output
range.
Continued on page 11
Current Setup Steps
IMPORTANT NOTE: Do not connect the device to the power supply when the power supply is already on.
SW5 SW6 SW7 Input Range Output Range
▼ ▼ ▼ 0–10 V 4–20 mA
▼ ▼ ▲ 0–10 V 5–25 mA
▲ ▼ ▼ 0–10 V 0–16 mA
▲ ▼ ▲ 0–10 V 0–20 mA
▼ ▲ ▼ 0–5 V 4–20 mA
▼ ▲ ▲ 0–5 V 5–25 mA
▲ ▲ ▼ 0–5 V 0–16 mA
▲ ▲ ▲ 0–5 V 0–20 mA