Dwyer 1600 - Manual (Page 5)

Rev. 10/98 5 949-1239-3
INPUT SELECTION
Before removing the instrument from its housing, make sure you take
appropriate precautions to avoid electro-static discharge (ESD). See
caution on opposite page. To change the input type, remove the instru-
ment from its housing by grasping the front bezel sides and pulling
forward to release it from
the housing lock.
Locate the dip switch on
the right pcb. Determine
the input type desired and
change the dip switch
setting as shown at the
right.
Reinstall the instrument
into the housing.
After changing input selec-
tion with the DIP switches,
be sure to change the InP
menu item (page 11) in the
Secure Menu.
1 2 3 4
DIP SWITCH LOCATION
THERMOCOUPLE INPUTS
RTD INPUTS
CURRENT INPUT
VOLTAGE INPUT
12 (0.450) * 3 (0.125)
45
(1.760)
114 (4.475)
125 (4.925)
48 (1.880)
48
(1.880)
R MADE IN USA
ENTER
AL AL
INDEX
˚C
˚F
SP2
AL
SP1
L O V E R CONTROLS CORP.
PV
SV
(All dimensions in millimeters with inches in parenthesis.)
Panel cutout for all models is 45mm x 45mm (1.775 in x 1.775 in).
Allow for 13 mm (0.5 in) clearance at the rear of the instrument.
* Present for SSR outputs.
DIMENSIONS