Changing the display mode, Exiting programming mode – Badger Meter Model IOG User Manual
Page 14

Changing the Display Mode
(For models ILR 700, 710, 720 and 730)
The display mode screen (indicated by a “d” on the top row, on the left side) determines the information displayed on the top
line of the register during normal operation The display mode may be either the Totalizer screen or the Flow Rate screen
“C,” indicates the Totalizer screen and “F” indicates the Flow Rate screen The Totalizer screen is depicted below:
Figure 8E: Default Display
1 While a letter is flashing on the display, press the RESET button to select either Totalizer or Flow Rate
2 Upon completion of this setting, the programming of the Industrial Standard Register and the Industrial Dual Pulse
Output is complete For ILR 710 and ILR 730 models, see additional programming parameters
OTEE:
N
For ILR 710 and ILR 730 models, see "Additional Programming: Industrial Analog and Industrial Pulse (ILR 710 & ILR
730)" on
Exiting Programming Mode
(For models ILR 700, 710, 720 and 730)
To exit the programing mode: On any screen, press and hold the both the TOTAL and RESET buttons The screen will revert
back to the programmed scale factor and then flash Following the three flashes, the register display will be blank
OTEE:
N
Pressing the TOTAL or RESET buttons will turn the display back on
Industrial Oval Gear Meter and Register
Page 14
May 2013