Badger Meter M-Series M2000 - Manual (Page 15)

Analog Output Calibration
Analog Output Calibration is an application embedded within the DD file that allows for remote configuration of the analog
output Navigate to Configuration > M2000 > Advanced > Analog Output and select D/A Trim Follow the on-screen instructions
for further details
Do not exercise the D/A Trim application if meter is configured in multi-drop mode The output current is fixed in multi-drop
mode (that is, Polling address is non-zero)
This application uses the custom offsets The deviation from 4 mA and 20 mA must be entered in terms of milliamperes
Recalibration will take effect once all offsets are configured and the application has completed
Figure 6 is an example of a diagram for a setup intended to assist in calibrating the analog output
42 41
250 Ω
Load
Polling Address = 0 44 43
Reference Meter
Fluke Amp Meter
Handheld Field
Communicator
Figure 6: Setup to Assist in Calibrating Analog Output
Installation & Operation Manual
Page 15 December 2012