Badger Meter ORION Classic (CE) - Manual (Page 19)

Installing the ME Driver
The ME Driver is required for communication between the ORS 2.2 software and an ORION ME/SE transceiver. Follow the
driver installation instructions for your operating system.
Installing the ME Driver for Windows 7
1. From the ORION Meter Reading System CD, Disc 1, copy the “MSP430_CDC.inf” file.
2. Click the Start button. Then click Computer and paste the MSP430_CDC.inf file on the C:\ drive of the laptop.
Result: The file appears in the C:\ drive as shown in Figure 35.
Figure 35: MSP430_CDC.inf on the C:\ Drive
3. Connect the ME/SE transceiver to a power supply
and to a USB port on the laptop.
When it is connected to the laptop, turn the ME/SE
transceiver power on.
Result: An error message is triggered and displays
briefly in the lower task bar. See Figure 36.
Figure 36: Device Driver error message
NOTE: N If the error message does not display automatically, disconnect the ME/SE transceiver and reconnect it. Make sure the
ME/SE transceiver is connected to a power supply and is switched on after you connect it to the USB port. The power
light should be on, indicating the transceiver is on.
4. Click the error message.
Result: The Driver Software Installation window opens
as shown in Figure 37.
5. Click the link: "What can I do if my device did not
install properly?"
Result: Windows Help opens with instructions for
installing the driver software. See Figure 38.
Figure 37: Driver Installation window
Installation Manual
Page 19 July 2012