Revo R4-8DVR4 - Manual (Page 51)

4 & 8 Channel Digital Video Recorder
45
Appendix
ERROR CODE NOTICES
SYSTEM UPGRADE RELATED BACKUP RELATED
No. Description No. Description
0 Unknown error. 0 Unknown error.
1 File version error. 1 Device error.
2 Operating system version error. 2 Mounting failed.
3 Software version error. 5 File already existed.
4 Kernel version error. 6 Not enough space.
100 Upgrade device mounting failed. 7 Creating temporary file failed.
101 Package is not found. 8 Opening disk failed.
102 Extracting package failed. 9 Formatting disk failed.
103 LILO failed. 10 Database has been changed.
104 Rebooting failed. 11 Appending failed.
105 Invalid package. 12 Bad sector.
300 Remote connection failed. 13 No executable file.
301 Remote network error. 14 Opening executable file failed.
302 Remote upgrade is not authorized. 15 Writing executable file failed.
303 Saving remote package failed. 16 Creating image failed.
304 Remote upgrade is cancelled by the user.
400 USB device mounting failed.
401 Reading upgrade package on the USB device failed.
402 Copying upgrade package on the USB device failed.
500 System is busy clip copying.
TROUBLESHOOTING
PROBLEM POSSIBLE SOLUTION
No Power
 Check power cord connections.
 Confirm that there is power at the outlet.
No Live Video
 Check camera video cable and connections.
 Check monitor video cable and connections.
 Confirm that the camera has power.
 Check camera lens settings.
DVR has stopped recording.
If hard disk drive is full, you will either need to delete video or set the DVR to the Recycle
On (Recycle When Disk Full) Mode. See Chapter 2 – Installation & Configuration,
Advanced Setup – Record Setup for details.
The icon displays, however,
the DVR is not recording.
When the DVR is in the Pre-Event recording mode, the yellow and icons display
when there is no event, and the DVR is not recording. The red and icons display
when any event occurs and the DVR starts recording.
IR remote control does not
work properly.
 Check the batteries in the remote control.
 Check that nothing blocks the infrared sensor on the DVR.
 Check the system ID setting for the remote control. See Chapter 2 – Installation &
Configuration, Advanced Setup – System Setup for details.
While upgrading the system, the
DVR keeps rebooting and the
upgrade fails. If the current system version is higher than the upgrade package file version, you should
reset the DVR first using the Factory Reset. When using the Factory Reset, you will lose
any settings you have saved.