Martel Electronics 3001 - Manual (Page 74)

*SRE IEEE-488 RS-232 Sequential Overlapped
Service Request Enable command. This command loads a byte into the Service Request
Enable (SRE) register. See the Service Request Enable Register (SRE) description in
section 9.7. Since bit 6 is not used (decimal value 64), the maximum entry is 255 - 64 =
191.
Parameter:
where is the decimal equivalent of the SRE byte, 0 to 191
Response:
Example: *SRE 48
This example enables bits 4 (MAV) and 5 (ESB).
*SRE? IEEE-488 RS-232 Sequential Overlapped
Service Request Enable query. This command returns the byte in the Service Request
Enable Register (SRE). See the Service Request Enable Register (SRE) description in
section 9.7.
Parameter:
Response:
where is the decimal equivalent of the SRE byte, 0 to 191
Example: *SRE?
48
This example indicates that bits 4 (MAV), and 5 (ESB) are enabled.
*STB? IEEE-488 RS-232 Sequential Overlapped
Status Byte Register query. This command returns the byte in the Status Byte Register.
See the Status Byte Register (STB) description in section 9.7.
Parameter:
Response:
where is the decimal equivalent of the STB byte, 0 to 255
Example: * STB?
96
This example indicates that bits 5 (ESB) and 6 (MSS) are set.
X X X
X X X
X X X
70