Martel Electronics 3001 - Manual (Page 64)

LOCKOUT IEEE-488 RS-232 Sequential Overlapped
This command puts the 3001 into the lockout state when in remote control (see the
REMOTE command). In this state, no local operation is allowed at the front panel,
including the LOCAL key. To clear the lockout condition, use the LOCAL command. This
command duplicates the IEEE-488 LLO (Local Lockout) message.
Parameter:
Response:
Example: LOCKOUT
This example puts the instrument into the lockout state. No front panel
controls can be used.
LOOP_POWER? IEEE-488 RS-232 Sequential Overlapped
This command returns the isolated DC current input 24V loop power status.
Parameter:
Response:
where is ON or OFF
Example: LOOP_POWER?
OFF
This example indicates that the isolated DC current input 24V loop
power is turned off.
LOOP_POWER_OFF IEEE-488 RS-232 Sequential Overlapped
This command disables the isolated DC current input 24V loop power.
Parameter:
Response:
Example: LOOP_POWER_OFF
This example disables the isolated DC current input 24V loop power.
LOOP_POWER_ON IEEE-488 RS-232 Sequential Overlapped
This command enables the isolated DC current input 24V loop power.
Parameter:
Response:
Example: LOOP_POWER_ON
This example enables the isolated DC current input 24V loop power.
X X X
X X X
X X X
X X
60