KROHNE UFC 400 PROFIBUS PA-PROFIBUS DP - Manual (Page 42)

4
COMMISSIONING / OPERATION
42
UFC 400
www.krohne.com 05/2014 - 4003118502 - AD UFC 400 PROFIBUS R02 en
How to read the mapping table above:
• If e.g. the diagnosis event bit of "Event group" ("I-") Electr: Info. Operation Electr: Info. Operation Electr: Info. Operation Electr: Info. Operation (81) has been set
the diagnosis event bit "Extension available Extension available Extension available Extension available" (55) will be set additionally.
• If e.g. the diagnosis event bit of "Event group" "C C C C – Sensor Sensor Sensor Sensor" (59) has been set both the
diagnosis event bit "Extension available Extension available Extension available Extension available" (55) and the diagnosis event bit "Function check"
(42) will be set additionally.
• If e.g. the diagnosis event bit of "Event group" "M M M M – Sensor Sensor Sensor Sensor" (67) has been set both the
diagnosis event bit "Extension available Extension available Extension available Extension available" (55) and the diagnosis event bit "Maintenance Maintenance Maintenance Maintenance
required required required required" (37) will be set additionally.
• If e.g. the diagnosis event bit of "Event group" "S S S S – Sensor Sensor Sensor Sensor" (71) has been set both the
diagnosis event bit "Extension available Extension available Extension available Extension available" (55) and the diagnosis event bit "Measurement Measurement Measurement Measurement
failure failure failure failure" (29) will be set additionally.
• If e.g. the diagnosis event bit of "Event group" "F F F F – Sensor Sensor Sensor Sensor" (63) has been set both the
diagnosis event bit "Extension available Extension available Extension available Extension available" (55) and the diagnosis event bit "Hardware failure Hardware failure Hardware failure Hardware failure
electronics electronics electronics electronics" (24) will be set additionally.
4.3.3 Variable "Event groups"
As already mentioned in the UFC 400 Handbook there are 7 "Event groups" available with a
variable classification ("F", "S", "M", "C" or "I"):
• ("I-") Electr: Power Failure
• ("S-") Config_ Totalizer
• ("S-") Proc: Signal Unreliable
• ("S-") Proc: Signal Lost
• ("S-") Proc: Empty Pipe
• ("S-") Electr: IO Connection
• ("F-") Proc: Current Input
If using the DTM or EDD DTM or EDD DTM or EDD DTM or EDD you are able to choose one of the following settings:
DTM: Enter menu: → "Parameters → Input → Diagnostics":
EDD: Enter menu:→ Online menu: "Device → Setup → Device → Diagnosis mapping and filter":
or
→ Offline menu: " → Offline → Setup → Device → Diagnosis mapping and filter":
CAUTION!
It is recommended
recommended recommended recommended to use the default default default default classification. If the default classification of a variable
"Event Group" should be changed please note: